Manuals

We have posted the most popular Apquip manuals in this section. 

Applicator Head

PDFPrintE-mail

Applicator Head

The only component in the Apquip system which requires particular alignment attention is the applicator head;  the head must be clean and correctly aligned in order to function properly.   

Read more: Applicator Head

 

Squeeze Out Adjustment

PDFPrintE-mail

Squeeze Out Adjustment - Once the applicator head has been correctly aligned, adhesive pattern adjustments can be performed.   The Apquip system employs a high speed optical sensor and solid state timers to insure a reliable, consistent adhesive pattern. 

Sensing Components Check - Before proceeding to adjustment, a quick check of the sensing electronics will verify that the system is set up correctly. There are three things to check:  

Read more: Squeeze Out Adjustment

   

Air Controls

PDFPrintE-mail

Air Controls -  Pressurized air lines are normally used at just two points in the Apquip System: 1.) air supply to pressurize the tank,  2.)  air supply to the control panel to operate the applicator valve. This system requires a maximum of 60 PSIG of clean, dry air.  Moisture and compressor blow-by will affect the performance of the system's spool/sleeve assembly.   The Apquip system includes both a brass, 5 micron filter and a white coalescing filter to remove normal levels of impurities.  Refer to drawing #012 for replacement part numbers. 

                              DO NOT LUBRICATE THE AIR SUPPLY.  

Read more: Air Controls

   

Fluid Supply

PDFPrintE-mail

Fluid Supply - Shut off the air supply to the pressure tank.   Disconnect the pressurized adhesive supply hose at the applicator valve assembly.   This hose may be under pressure, so loosen the fitting slowly.  Place the end of the hose over a small container.

Read more: Fluid Supply

   

Electrical Controls

PDFPrintE-mail

Electrical Controls - The small red indicator visible in the sensor housing (near the cable) glows when the control panel is energized;  it goes out when the sensor detects an object up to 1-1/2" from the edge of the aluminum sensor housing.

Proceed with caution, some tests are performed with the control panel energized - some components will be at line voltage.

Read more: Electrical Controls

   

More Articles...

Page 1 of 2

escort bayan escort bayan